Fujitsu AOU48RLXFZ1 - Setting Method Navigation

En-29
Setting method(1)
UsetheMODE/EXIT,SELECT,andENTERbuttonstoconguresettingsaccordingtotheproceduresbelow.
1: Function Setting
2: Setting the
rst2digits
3: Setting the
last 2 digits
(When [F3] to [F9] are displayed, continue to press
the SELECT button until [F2] is displayed.)
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
: Press the “MODE/EXIT” button.
: Press the “SELECT” button.
: Press the “ENTER” button.
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
Press“ENTER”buttontoreturnto“2.Settingtherst2digits”
(If there is no operation for 5 seconds after the setting, the
displaywillreturnto“2:Settingtherst2digits”.)
(If there is no operation for 5 seconds after the setting,
thedisplaywillreturnto“2:Settingtherst2digits”.)
(Press the MODE/EXIT button to cancel the setting mode.)
Setting is complete when the lamp lights up
Setting is complete when the lamp lights up
(Press the ENTER button for more
than 3 seconds.)
(Press the ENTER button for
more than 3 seconds.)
7 seg. display
First 2 digits
Last 2 digits
(Blinking)
(Blinking)
(Blinking) (Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
Every press of the “SELECT”
button will change the setting
numberfortherst2digits.
MODE/EXIT
MODE/EXIT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
ENTER
ENTER
ENTER
ENTER
EXIT
ENTER
ENTER
MODE/EXIT
Press“ENTER”buttontoreturnto“2.Settingtherst2digits”
9379069342-02_IM.indb 29 17/5/2556 11:50:00