¢
Forced stop
• In the case of "Edge" input
Function
setting
External Input and
Output PCB
External input Input signal Command
Rotary
switch
SW302
46-02
— Input of indoor unit CN46
Off → On
Forced stop
(R.C. disabled)
On → Off
Normal
(R.C. enabled)
1 Edge
External Input and
Output PCB
CN313
Off → On
Forced stop
(R.C. disabled)
On → Off
Normal
(R.C. enabled)
On
Off
Forced stop
Normal
On
Off
Remote controller
On On
Indoor unit operation
On
CN313
• In the case of "Pulse" input
Function
setting
External Input and
Output PCB
External input Input signal Command
Rotary
switch
SW302
46-02 1 Pulse
External Input and
Output PCB
CN313
Pulse
Forced stop
(R.C. disabled)
CN314
Normal
(R.C. enabled)
On
Off
On
Off
Remote controller
On
Off
Forced stop
Normal
CN313
CN314
On On On
Indoor unit operation
NOTES:
• When the forced stop is triggered, indoor unit stops and Operation/Stop operation by the remote
controller is restricted.
• When forced stop function is used with forming a remote controller group, connect the same
equipment to each indoor unit within the group.
2-4. Details of control input function
- (05-17) - 2. External input and output
FIELD
WORKING
FIELD
WORKING
To Next Page
Loading...
