08-18
Fan delay setting
JUMPER WIRE SETTING
Room temperature correct coefficient of cooling.
Commercial mode setting
( Factory setting)
( Factory setting)
"Hot start" can be canceled,fan operates continously when indoor unit is ON on every mode.
When you select "FAN:AUTO"mode fan goes in "HIGH".
This setting can be used when the auxiliary heater is mounted.
When the fan operation is stopped when the indoor unit is operating
with an auxiliary heater,the fan operation continues one minutes.
EXTERNAL INPUT AND OUTPUT
JM2 JM state
Connect Residencial
Disconnect Commercial
JM3 JM state
Connect Invalidity
Disconnect Validity
Connector INPUT OUTPUT REMARKS
CN114
CONTROL INPUT
(OPERATION/STOP)
-
CN115 - OPERATION DISPLAY
CN14 - FRESH AIR
CN15 - ELECTRICAL HEATER
See external
input/output settings
for details.
Decide the cooling temperature correct coefficient value of cooling.
( Factory setting)
JM1 JM state
Connect 0 deg
Disconnect + 2 deg
Cool temperature corrction
To Next Page
Loading...
