08-20
2-1 Room temperature correct coefficient of heating.
2-2 Control input setting
2-3 Auto restart setting
1. SW1 setting
2. SW2 setting
1-1 Dip SW 1-1,1-2,1-3,1-4 setting forbidden
( Factory setting)
( Factory setting)
DIP SWITCH SETTING
SW1-1 OFF
SW1-2 OFF
SW1-3 OFF
SW1-4 OFF
SW2-1 SW state
OFF Ceiling setting (+4
°C
)
ON Room setting ( 0
°C
)
SW2-2 SW state
OFF Edge
ON Pulse
SW2-3 SW state
OFF Validity
ON Invalidity
Auto restart function can be selected by turning this switch ON/OFF.
Decide the heating temperature correct coefficient vale of heating.
Heat temperature corrction
This switch is used to select the format of external input command
as shown in the table below.
This switch can be used when group control system.
Set the indoor unit address in the 1,2,-,15 order.
SW3 SW state
0 single
1-15 Indoor unit address
ROTARY SWITCH SETTING
( Factory setting)
( Factory setting)
( Factory setting)
To Next Page
Loading...
