08-21
Fan delay setting
JM1 setting forbidden
Commercial mode setting
( Factory setting)
( Factory setting)
JUMPER WIRE SETTING
( Factory setting)
"Hot start" can be canceled,fan operates continously when indoor unit is ON on every mode.
When you select "FAN:AUTO"mode fan goes in "HIGH"
This setting can be used when the auxiliary heater is mounted.
When the fan operation is stopped when the indoor unit is operating
with an auxiliary heater,the fan operation continues one minutes.
EXTERNAL INPUT AND OUTPUT
JM1 SW state
Connect
Disconnect
JM2 SW state
Connect Residencial
Disconnect Commercial
JM3 SW state
Connect Invalidity
Disconnect Validity
Connector INPUT OUTPUT REMARKS
CN114
CONTROL INPUT
(OPERATION/STOP)
-
CN115 - OPERATION DISPLAY
CN14 - FRESH AIR
CN15 - ELECTRICAL HEATER
See external
input/output settings
for details.
To Next Page
Loading...
