Fujitsu ARTG65LHTA - Contrast Setting; Filter Sign Setting; Filter Sign Reset Setting; Display Setting

z
5-3-3. Contrast setting
1
In “Screen” screen, select [Contrast] with the [Cursor
button (Left/Right)], and set with the [Cursor button (Up/
Down)].
30S
Screen
Automatic
off time
Brightness
Contrast
Mo 10:00
Date and time
Filter sign
Cancel:
OK:
NOTE
• The set is reected while setting it.
2
Other screen setting items can be set continually. To
complete the setting, press the [Enter button].
Screen returns to the “Submenu” screen.
5-4. Filter sign setting
NOTE
• This function can be used only if the setting is activated in
the installation. To activate this function, consult authorized
service personnel.
In “Submenu” screen, select [Filter sign] with the [Cursor but-
ton (Up/Down)], and press the [Enter button].
Date and time
Monitor
Screen
Filter sign
R.C. sensor control
Room temp. display
Off
Off
Mo 10:00
Setting:
Back:
Submenu
[
1/2
]
“Filter sign” screen is displayed.
Screen
Display
Filter sign reset
Filter sign
Initial
Off
Mo 10:00
Setting:
Back:
z
5-4-1. Filter sign reset setting
If lter sign icon
is displayed on the “Monitor” screen,
clean the air lter on the relevant indoor unit rst, and then
reset the lter sign as follows:
NOTE
• Before resetting the lter sign on this remote controller,
clean the air lter on the relevant indoor unit. Refer to
“7. CLEANING AND CARE”.
1
In the “Filter sign” screen, select [Filter sign reset] with the
[Cursor button (Up/Down)], and press the [Enter button].
Screen
Display
Filter sign reset
Filter sign
Initial
On
Mo 10:00
Setting:
Back:
Following screen is displayed.
The filter sign will be reset. OK?
No
Yes
2
Select [Yes] or [No] with the [Cursor button (Left/Right)],
and press the [Enter button].
When [Yes] is selected, the lter sign icon on the display
is turned o󰀨.
11
z
5-4-2. Display setting
You can select [On] (display) or [O󰀨] (non-display) for the lter
sign icon indication.
NOTE
• When you set this setting to [O󰀨], the lter sign icon will not
be displayed regardless of the necessity of lter cleaning on
the indoor unit.
1
In the “Filter sign” screen, select [Display] with the [Cursor
button (Up/Down)], and press the [Enter button].
Following screen is displayed.
Screen
Display
Filter sign reset
Filter sign
Initial
Off
Mo 10:00
Setting:
Back:
En-24
9381067213-01_OM_En_200904.indd 24 2020/09/04 10:21:49