EasyManuals Logo

Fujitsu ASTA30LFC User Manual

Fujitsu ASTA30LFC
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
5
PREPARATION
CAUTION!
Take care to prevent infants from
accidentally swallowing batteries.
When not using the Remote Controller
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trollers operating range becomes appre-
ciably reduced, replace the batteries and
press the RESET button with the tip of a
ballpoint pen or other small object.
Load Batteries (R03/LR03
××
××
× 2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 6 X).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 6 P) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 6 X) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
The Remote Controller must be pointed at signal receiver (Fig. 1 4) to operate
correctly.
Operating Range: About 7 meters.
When a signal is properly received by the air conditioner, a beeping sound will
be heard.
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3 To remove the Remote
Controller (when use at
hand).
1 Mount the Holder. 2 Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
9315345301_OM_EN_body 3/22/10, 10:40 AM5

Other manuals for Fujitsu ASTA30LFC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu ASTA30LFC and is the answer not in the manual?

Fujitsu ASTA30LFC Specifications

General IconGeneral
BrandFujitsu
ModelASTA30LFC
CategoryAir Conditioner
LanguageEnglish

Related product manuals