En-5
3 To remove the Remote
Control Unit (when use at
hand).
1 Mount the Holder. 2 Set the Remote Control Unit.
Screws
Insert
Press in
Slide up
Pull out
Set the Current time
1
Press the TIME ADJUST button (Fig. 6 O).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the ( ) SET TIME buttons (Fig. 5 I) to adjust
the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the TIME ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
● The remote control unit must be pointed at signal receiver (Fig. 1 4) to operate
correctly.
● Operating range: About 7 meters.
● When a signal is properly received by the air conditioner, a beeping sound will
be heard.
● If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
● Signals will not be transmitted properly if a wall, cur-
tain, or other object is between the air conditioner and
the remote control unit.
● The air conditioner may fail to operate properly if
strong direct light is allowed to strike the signal re-
ceiver. Use a curtain to shade strong sunlight from
windows, and place strong lamps at a distance away
from the signal receiver.
● If another electric appliance is operated by the remote
control unit move the appliance away or consult with
authorized service personnel.
● Do not place the remote control unit in locations where
it may be subjected to heat from direct sunlight or
from heating apparatus.
● Do not subject the remote control unit to strong im-
pacts, and do not allow water or other liquids to splash
on it.
● When the remote control unit is used in rooms fur-
nished with instant-lighting type fluorescent lamps,
the air conditioner may fail to receive control signals
correctly. Consult with authorized service personnel
when purchasing a new fluorescent lamp.
To Next Page
Loading...
Need help?
General
