EasyManua.ls Logo

Fujitsu ASYA24LCC - Adjusting the Direction of Air Circulation

Fujitsu ASYA24LCC
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
En-9
ADJUSTING THE DIRECTION OF AIR CIRCULATION
Vertical (up-down) direction of airflow is adjusted by pressing the Remote Controller’s SET button. Horizontal (right-left) air-
flow direction is adjusted manually, by moving the Air Flow Direction Louvers.
Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical air direction
louvers are stopped.
R
DANGER!
Never place fingers or foreign objects in-
side the outlet ports, since the internal fan
operates at high speed, and personal injury
could be caused.
Always use the Remote Controller’s
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper op-
eration; in this case, stop operation and
restart. The louvers should begin to
operate properly again.
During use of the Cooling and Dry
modes, do not set the Airflow Direc-
tion Louvers in the Heating range (4 -
6) for many hours, since water vapor
may condense near the outlet louvers
and drops of water may drip from the
indoor unit. During the Cooling and
Dry modes, if the Airflow Direction
Louvers are left in the heating range
for more than 30 minutes, they will
automatically return to position 3.
When used in a room with infants, chil-
dren, elderly or sick persons, the airflow
direction and room temperature should
be considered carefully when making
settings.
Vertical Air Direction Adjustment
Press the SET button (Fig. 6 U).
Each time the button is pressed, the air direction range will change as follows:
1 2 3
4 5 6
Types of Air flow Direction Setting:
1,2,3 : During Cooling/Dry modes
4,5,6 : During Heating mode
The Remote Controller’s display does
not change.
Use the air direction adjustments within the ranges shown above.
The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry mode
: Horizontal flow 1
During Heating mode : Downward flow 6
During AUTO/HEAT mode operation, for the first one minute after beginning op-
eration, airflow will be horizontal 1; the air direction cannot be adjusted during
this period.
Right-Left Adjustment
Adjust the Right-Left louvers.
Move the Right-Left louvers to adjust air flow in the direction you prefer.
R
DANGER!
When adjusting the Right-Left Louvers, it
is necessary to stop the Air-Conditioner
first and make sure that it stops completely
before adjusting the direction.
knob(two places)
Right-Left Louvers
1
2
3
4
5
6
knob

Other manuals for Fujitsu ASYA24LCC

Related product manuals