Fujitsu ASYA24LCC - Specifications

En-3
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
● The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
● When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (green)
6 TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 15 Auto Restart).
7 COIL DRY Indicator Lamp (yellow)
8 Intake Grille (Fig. 4)
9 Fornt Panel
0 Air Filter
A Airflow Direction Louver
B Right-Left Louver
(behind Airflow Direction Louver)
C Drain Hose
D Power Supply Plug
E Power Supply Cord
F Air Cleaning Filter
Fig. 5 Outdoor Unit
G Intake Port
H Outlet Port
I Pipe Unit
J Drain port (bottom)
NAME OF PARTS
● Refer to the folded out page on the cover.
Fig. 6 Remote Controller
K Signal Transmitter
L MODE button
M 10°C HEAT button
N SET TEMP. button (
/ )
O COIL DRY button
P SLEEP button
Q TIMER MODE button
R FAN button
S START/STOP button
T ECONOMY button
U SET button
V SWING button
W TIMER SET (
/ ) button
X CLOCK ADJUST button
Y TEST RUN button
● This button is used when installing the air
conditioner, and should not be used un-
der normal conditions, as it will cause the
indoor unit’s thermostat function to oper-
ate incorrectly.
● If this button is pressed during normal op-
eration, the indoor unit will switch to test
operation mode, and the Indoor Unit’s OP-
ERATION Indicator Lamp and TIMER
Indicator Lamp will begin to flash simulta-
neously.
● To stop the test operation mode, press the
START/STOP button to stop the air
conditioner.
Z RESET button
[ Remote Controller Display (Fig. 7)
\ Transmit Indicator
] Fan Speed Display
` SWING Display
a Timer Mode Display
b Clock Display
c Temperature SET Display
d ECONOMY Display
e Operation Mode Display
f COIL DRY Display
g SLEEP Display