REPLACEMENT PARTS
09-13
Model : AOYR24LCC
PROCESS Assemble COIL, CHOKE and WIRE with TERMINAL
COIL, CHOKE
SCREW, TAPTITE
WIRE with TERMINAL
REGULATIONS
Like a rough sketch, assemble COIL, CHOKE to CASE ( INV )
Like a rough sketch, assemble WIRE with TERMINAL after assembling COIL, CHORK.
(Pay attention to direction of WIRE with TERMINAL.)
Like a rough sketch, twist WIRE with TERMINAL and assemble it certainly.
(Twist it 1 time is to twist 360 .)
Five times (Width of twist. 40~50mm)
CASE (INV)
Tighten COIL, CHOKE with SCREW
after insert STOPPER.
Don't come off from the STOPPER.
COIL, CHORK
SCREW, TAPTIATE
WIRE with TERMINAL
STOPPER
1
2
2
1
3
3
To Next Page
Loading...
