6. SYSTEM DESIGN
FUNCTION SETTING

(5) Press the "10°C HEAT" button to access
the fuction setting mode.
(6) Press the "TEMP. " or "TEMP. "
buttons to select the function number.
Press the "10°C HEAT" button to switch
between left and right digits.
(7) Press the "POWERFUL" button to proceed
to the setting number.
(Press the "POWERFUL" button again to
return to the function number selection.)
(8) Press the "TEMP.
" or the "TEMP. "
buttons to select the setting number.
Press the "10°C HEAT" button to switch
between left and right digits.
(9) Press the "MODE" button once to send the
function mode information.
(10) Press the "
/
"
button once to îš¿î™› the
function setting.
A beeping noise will be heard if the
command is accepted.
*Wrong code: No Response
Note: Please push the " / " button within 30 seconds
after pushing the "MODE" button.
FUNCTION DETAILS

Refer to 5-6. FUNCTION DETAILS
Change digit
Change digit
Pi Pi
Pi Pi
- (06 - 70) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
Need help?
General
