6. SYSTEM DESIGN
SWITCHING SELECTION OF FUNCTION SETTING MODE
2) To activate the function setting mode, hold down the three buttons "Set Temp.
q
", "Set
Temp.
p
" and "Fan" at the same time for 5 seconds or longer.
Function setting mode initial display
BUTTON NAME AND FUNCTION
During function setting mode, indoor unit will reject any operation command from the remote
controller.
Function number
Refer to FUNCTION DETAILS
Remote controller address
Fixed to 00.
Fan button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Refer to FUNCTION DETAILS
Start/Stop button
Transmits function setting
Set Temp. “
p
” and “
q
” button
Switches the various numbers.
- (06 - 81) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
Need help?
General
