EasyManuals Logo

Fujitsu ASYG09LUCA User Manual

Fujitsu ASYG09LUCA
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #310 background imageLoading...
Page #310 background image
6. SYSTEM DESIGN
REMOTE CONTROLLER CUSTOM CODE SETTING
According to the following instructions, please set the custom code settiing of the Wireless remote
controller to match any changes in the custom code setting of the indoor unit.
(Note that the air conditioner cannot receive a signal if the right custom codes has not been set.)
1.Press the START/STOP button until only the
clock is displayed on the remote controller
display.
. Press the  button or at east e
seconds to display the current custom code
(initially set to "A").
3.Press the SET TEMP. “
p
” or the “
q
button to change the custom code between
bcd.
4.Press the MODE button again to return to
the clock indicator. The custom code will be
changed.
If no buttons are pressed within 30 seconds after the custom code is displayed, the system
returns to the original clock indicator. In this case, start again from step 1.
The air conditioner custom code is set to "A" prior to shipment.
The remote controller resets to custom code "A" when the batteries in the remote controller are
replaced. If you use a custom code other than custom code "A", reset the custom code after
replacing the batteries. If you do not know the air conditioner custom code setting, try each of
the custo codes bcd unti ou ind the code which operates the air conditioner.
- (06 - 62) -
SYSTEM
DESIGN
SYSTEM
DESIGN

Table of Contents

Other manuals for Fujitsu ASYG09LUCA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu ASYG09LUCA and is the answer not in the manual?

Fujitsu ASYG09LUCA Specifications

General IconGeneral
BrandFujitsu
ModelASYG09LUCA
CategoryAir Conditioner
LanguageEnglish

Related product manuals