Fujitsu AUT36A User Manual

11
About the DAY OFF
● Use the DAY OFF setting to switch off timed operation for a selected day in the coming week.
● This is a temporary, one-time setting. The DAY OFF setting is automatically cleared as soon as the specified day passes.
Next day
Example: To switch off timed operation
for day 2 (Tuesday)
NOTES:
(1) The DAY OFF setting is only available for days for which weekly time settings already exist.
(2) You can make this setting for any of the next seven days (counting from the current day).
(3) The DAY OFF setting is effective over the range illustrated below. The Weekly setting for which an ON time has been
set is eligible for the day in which the DAY OFF has been set.
(4) The display on the clock’s lower line will usually be “
” for the DAY OFF set day during Weekly operations.
CLOCK
TIMER
DAY
WEEKLY
AUTO
ON
OFF
DAY OFF
TIMER
MODE
SET
ZONE
START/STOP
CLOCK ADJUST
SET TIME TEMP./DAY FAN
CONTROL
MASTER
CONTROL
21
HIGH
AUTO
COOL
DEFROST TEST
DAY OFF
ENERGY SAVE
2
ON OFF
0:00 0:00
Effective range of DAY OFF setting
WEEKLY setting for preceding
day
WEEKLY setting
Preceding day DAY OFF day
°C
CLOCK
TIMER
TEMP
WEEKLY
AUTO
DAY OFF
TIMER SET TIME TEMP /DAY FAN
21
HIGH
AUTO
COOL
DEFROST TEST
Using the DAY OFF Setting
Press the START/STOP button to stop the air conditioner, and then proceed as fol-
lows.
1
Carry out steps 1 to 2 of the “Setting Up the Weekly
Timer Operation” procedure to select the day that you
want to set as the DAY OFF.
2
Press the DAY OFF button.
The DAY OFF setting is registered, and the DAY OFF caption appears on
the display.
● To cancel the DAY OFF setting:
You can cancel the setting by pressing the DAY OFF button again.
ON OFF
Precautions during setup
Setup is not possible in the following cases, so amend the time.
● If you set an ON time while leaving the OFF time setting blank:
Nothing will happen when you press the SET button.
To proceed, press the SET TIME button and enter an appropriate setting.
● When an attempt is made to set only the OFF time.
Nothing will happen when you press the SET TIME button.
Press the SET button and amend the entry for the ON time.
● ON and OFF times cannot be set to the same value.
● The OFF time cannot be set earlier than the ON time.
● The WEEKLY 2 settings cannot be set earlier than the WEEKLY 1 settings.
● The WEEKLY 1 and WEEKLY 2 time spans cannot overlap.

Fujitsu AUT36A Specifications

General

Brand	Fujitsu
Model	AUT36A
Category	Air Conditioner
Language	English