This section describes how to clean the scanner.
ATTENTION
In order to use the cleaning materials safely and correctly, read the precautions on each
product thoroughly.
100 ml
Liquid cleaner to use for removing dirt and stains
20 sheets/pack
This is an A4 size-cleaning sheet.
Use two sheets to clean once.
24 packets
Pre-moistened with Cleaner F1. It can be used
instead of moistening a cloth with Cleaner F1.
Used to clean a tiny part such as the
document sensor.
Used to wipe off dirt and stains. Moisten it
with Cleaner F1 for cleaning.
●
Do not use aerosol spray or spray that contains alcohol. Paper dust blown
up by strong air from the spray may enter inside the scanner, which may
cause the scanner to fail or malfunction.
Also note that sparks generated by static electricity may cause a fire.
●
The inside of the ADF becomes very hot when the scanner is being used.
Before you start cleaning the inside of the ADF, make sure to turn off the
power, unplug the power cable and wait for at least 15 minutes for the
inside of the ADF to cool down.
For more information about the cleaning materials, contact the distributor/dealer where you
purchased this product. Refer to the contact information in the Contact List or the Contact
for Inquiries section in Safety Precautions bundled with this product and make an inquiry.
To Next Page
Loading...
