Fujitsu FI-800R - Cleaning the Inside of the Scanner (ADF) with Cleaning Paper

The inside of the ADF can be cleaned with a sheet of Cleaning Paper moistened with
Cleaner F1.
As the scanner continues to feed the documents, paper dust will accumulate inside the ADF
and it may cause scanning errors. Cleaning should be performed approximately every 1,000
sheets scanned. Note that this guideline varies depending on the types of documents you
scan. For instance, it may be necessary to clean the scanner more frequently when you
scan documents on which the toner is not sufficiently fused.
1. Turn on the scanner
2. Spray the Cleaning Paper with Cleaner F1
3. Insert the Cleaning Paper into the return path opening or load the Cleaning Paper in
the ADF paper chute (Feeder).
Inside the ADF should be cleaned from both the return path opening and the ADF
paper chute (feeder).
o For the return path opening
Insert the Cleaning Paper into the return path opening.
Cleaning the Inside of the Scanner (ADF) with Cleaning
Paper
 ATTENTION
 Do not use water or mild detergent to clean the ADF.
 It may take a long time to dry if an excessive amount of Cleaner F1 is used.
Use only a small amount. Wipe off the cleaner completely to leave no
residue on the cleaned parts.