STEP 2: Selecting the function number and setting value
1. Press the SET TEMP. ( ) ( ) buttons to select the function num-
ber. To switch between the left and right digits, press the MODE
button.
2. Press the FAN button to proceed the setting value. To return the
function number selection, press the FAN button again.
3. Press the SET TEMP. ( ) ( ) buttons to select the setting value.
To switch between the left and right digits, press the MODE button.
4. Press the TIMER MODE button, and START/STOP button, in the
order listed to confirm the settings.
5. Press the RESET button to cancel the function setting mode.
6. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
Function number
Setting value
CAUTION
After disconnecting the power supply, wait 30 seconds or more before reconnecting it. The function
setting will not become active unless the power supply is disconnected and then reconnected.
- 29 -
10-2. Function settings by using remote controller 10. Function settings
CASSETTE TYPE
AUHG18-24LVL
CASSETTE TYPE
AUHG18-24LVL
To Next Page
Loading...
