¢
Custom code setting for wireless remote controller
To interconnect the air conditioner and the wireless remote controller, assignment of the custom
code for the wireless remote controller is required.
NOTE:
Air conditioner cannot receive a custom code if the air conditioner has not been set for the
custom code.
1. Press the START/STOP button until only the clock is displayed on the remote controller dis-
play.
2. Press the MODE button for at least 5 seconds to display the current custom code. (Initially set
to .)
3.
Press the SET TEMP. ( or ) button to change the custom code between → → → .
Match the code on the display to the air conditioner custom code.
4. Press the MODE button again to return to the clock indicator. The custom code will be
changed.
NOTES:
• If no button is pressed within 30 seconds after the custom code is displayed, the system returns
to the original clock indicator. In this case, start again from step 1.
•
The air conditioner custom code is set to
prior to shipment. To change the custom code, con-
tact your retailer.
•
The remote controller resets to custom code when the batteries in the remote controller are
replaced. If you use a custom code other than code , reset the appropriate custom code after
replacing the batteries. If you do not know the assigned code for the air conditioner, try each of
the custom code ( → → → ) until you find the code which operates the air conditioner.
- 33 -
10-2. Function settings by using remote controller 10. Function settings
CASSETTE TYPE
AUHG18-24LVL
CASSETTE TYPE
AUHG18-24LVL
To Next Page
Loading...
