Fujitsu Inverter Halcyon 9374379378 - OPERATION MODES AND SETTINGS; Setting Operation Mode & Temperature; Fan Speed and Economy Settings

En-4
To set the operation mode
● Operation mode setting
● Room temperature setting
● Fan speed setting
AUTO COOL DRY HEATFAN
AUTO MEDHIGH LOW QUIET
Temperature setting range
AUTO ............................................... 64 to 88 °F
COOL/DRY ....................................... 64 to 88 °F
HEAT ................................................ 60 to 88 °F
Lower Rise
Press the MODE button to set the operation mode.
If DRY is selected, the fan speed will be set to AUTO.
Press the SET TEMP. buttons to set the room temperature.
Press the FAN button to set the fan speed.
Press the ECONOMY button to start or stop ECONOMY OPERA-
TION.
For details on the function, refer to page 13.
ECONOMY OPERATION
Room temperature sensor selection
Press the ECONOMY button for more than 2 seconds to
select whether the room temperature is detected at the in-
door unit (remote sensor) or the remote controller.
When the
thermo sensor display appears, the room
temperature is detected at the remote controller.
NOTES
• This function is locked at the factory. In order to detect the room temperature correctly, consult authorized service
personnel when using this function.
• If this function is locked, the location where the room temperature is detected cannot be changed and the
mark flashes when the ECONOMY button is pushed for 2 seconds or more.
Indoor unit
08M516_9374379378_en 2009.01.19, 14:094