66
Problem
Other computers
are not displayed when
the [Network Computer]
icon is double-clicked.
Possible Cause
The TCP/IP protocol is
not installed, or, the IP
address is not set
correctly.
No communication due to
poor radio signal.
Possible Solution
If the TCP/IP protocol is installed, do the
following to check the IP address:
1. Windows 2000:
Click [Start] → [Programs] →
[Accessories] → [Command Prompt].
Windows XP:
Click [Start] → [All Programs] →
[Accessories] → [Command Prompt].
2. Enter “ IPCONFIG” command, and
press [Enter].
(If your hard disk is C drive, enter
C:\>ipconfig)
Check that the IP address is correctly
displayed under the IP Address.
Example: IP address: 10.0.1.3
Subnet Mask: 255.255.255.0
Default Gateway: 10.0.1.1
Shorten the distance between computers
or remove visible obstacles between
them, and retry the connection.
LB01_Brie (59-70) 17/10/02, 5:34 PM66
To Next Page
Loading...
