40
LifeBook N Series User’s Guide
Shutdown and Startup Problems
The Power and
Suspend/Resume
button does not
work.
The Power and
Suspend/Resume
button is disabled
from the Power ->
Advanced submenu of
the setup utility.
Enable the button from the setup utility.
You did not hold the
button in long
enough.
Hold the button longer. This may need to
be a few seconds if your application is
preventing the CPU from checking for
button pushes.
There may be a
conflict with the
application software.
Close all applications and try the button
again.
The system
powers up and
displays power-
on information,
but fails to load
the operating
system.
The boot sequence
settings of the setup
utility are not compat-
ible with your
configuration.
Set the operating source by pressing the
[ESC] key while the Fujitsu logo is on
screen or use the [F2] key and enter the
setup utility and adjust the source settings
from the Boot menu.
You h ave a se c ured
system requiring a
password to load your
operating system.
Make sure you have the right password.
Enter the setup utility and verify the Secu-
rity settings and modify them accordingly.
Internal hard drive
was not detected.
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to
try to auto detect the internal hard drive.
Your system
display won’t
turn on when the
system is turned
on or when the
system has
resumed.
The system may be
password-protected.
Check the status indicator panel to verify
that the Security icon is blinking. If it is
blinking, enter your password.
Problem Possible Cause Possible Solutions
To Next Page
Loading...
