vi
LifeBook N Series User’s Guide
AUSTRALIAN WARNINGS
WARNING
FOR SAFETY REASONS, ONLY
CONNECT EQUIPMENT WITH A
TELECOMMUNICATIONS COMPLI-
ANCE LABEL. THIS INCLUDES
CUSTOMER EQUIPMENT PREVIOUSLY
LABELLED PERMITTED OR CERTI-
FIED.
Connection of Non Certified/Approved
peripherals may result in the equip-
ment operating outside the Australian
EMI Standards.
Modems connected to the Australian tele-
communications network must be oper-
ated in accordance with the Labelling
Notice. This modem has been specifically
configured to ensure compliance with the
ACA Standards. Do not adjust your
modem or software outside the values
indicated below. To do so would result in
your modem being operated in a non-
compliant manner.
Call Attempts/Retries:
Applications software shall be configured
so that no more than 3 attempts are made
to establish a connection to a given
number (Note: if the modem can detect
service tones, up to 10 attempts can be
made). If the call sequence is unsuccessful,
there shall be a delay of at least 30 minutes
before attempting to call the number
again.
Failure to set the modem and any applica-
tion software used with the modem, to the
values shown above will result in the
modem being operated in a non-
compliant manner. Consequently, this
would be in violation of the Labelling
Notice for this equipment and the Tele-
communications Act 1997 prescribes
penalties for the connection of non-
compliant equipment.
To Next Page
Loading...
