118
- Care and Maintenance
Figure 43. Removing/installing the dust filter access cover
5 Put back the dust filter access cover by inserting the end without latch first (positioning the key inside first), and
pushing in the cover until it latches.
To remove the dust filter cover:
1 Turn off the computer and disconnect the AC adapter.
2 Close the display and turn the system upside down.
3 Remove the dust filter access cover by pressing the
latch toward the center of the cover and lifting it out
(Fig.
43).
4 Clean the dust filter and the air-cooling duct using a
vacuum cleaner attachment (such as an extension
wand).
ALWAYS BE SURE THE DUST FILTER ACCESS COVER IS INSTALLED WHEN RUNNING YOUR SYSTEM. NOT
USING THE FILTER COVER COULD CAUSE CONTAMINATION AND POSSIBLE DAMAGE TO THE SYSTEM.
To Next Page
Loading...
