84
- Device Ports
External Video Port
The external video port allows you to connect
an external monitor or LCD projector. In order
to connect an external device follow these easy
steps:. There is also an external VGA monitor
port on the port replicator (Figure 39).
1 Align the connector with the port opening.
2 Push the connector into the port until it is
seated.
3 Tighten the two hold-down screws, located on
each side of the connector.
Figure 38. Connecting an External Video Device
W
HEN AN EXTERNAL MONITOR IS PLUGGED IN, PRESSING THE [FN] + [F10] KEYS ALLOWS YOU TO
CHANGE YOUR SELECTION OF WHERE TO SEND YOUR DISPLAY VIDEO. EACH TIME YOU PRESS THE KEY
COMBINATION, YOU WILL STEP TO THE NEXT CHOICE. THE CHOICES, IN ORDER, ARE: BUILT-IN DISPLAY
PANEL ONLY, EXTERNAL MONITOR ONLY, BOTH BUILT-IN DISPLAY PANEL AND EXTERNAL MONITOR, HDMI
DISPLAY, AND BOTH LCD AND HDMI. NOTE THAT DEPENDING UPON SYSTEM CONFIGURATION, ALL OF
THESE STEPS MAY NOT BE AVAILABLE.
To Next Page
Loading...
