19
Explicit Self-install
Connecting the LAN Connector
This section decribes the steps to connect the
LAN cable to LAN connector.
1. Lift up the unit from right side where LAN
connector is installed and pull out the LAN
connector in the direction of the arrow as
shown.
When the LAN cable is pulled strongly,
LAN connector may be disconnected
from the LIFEBOOK.
If LAN connector is disconnected from
the LIFEBOOK, power off the notebook
and plug in the LAN connector as
shown in the picture below.
2. Pull up LAN connector in the direction of the
arrow as shown and connect LAN cable to
the connector.
To Next Page
Loading...
