Removing and inst alling components
during servicing
Attaching the cover
1
1
2
► Place the cover in the correct mou nting position (1).
► Fasten the screws (2).
► Replace the dust chamber cover (see "
Removing and fitting the dust removal
cover (ventilation slo t cover)", Pag e 63).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare your device for operation again as follows:
► Install the battery again (see "
Installing a battery", Page 56).
► Turn the notebook the right way up again and place it on a flat surface.
► Reconnect the cables that yo u disconnected before.
Fujitsu Technology Solutions 97
Downloaded from LpManual.com Manuals
To Next Page
Loading...
