First-time setup of your device
Selecting a location
SelectingalocationDeviceMainsadapter
Select a suitable location for the device before setting it up. Follow
the instructions below when doing so:
• Never place the device or the mains adapter on a heat-sensitive surface.
The s urface could be damaged as a resu lt.
• Never place the device on a soft surface (e.g. carpeting, upholstered furniture,
bed). This can block the air vents and cause overheating and damage .
• The underside of the device heats up during normal operation. Prolonged con tact
with the skin may become unpleasant or even result in burns.
• Place the device on a stable, flat, non-slippery surface. Please note that the
rubber feet of the device may mark certain types of delicate surfa ces.
• Keep other objects a t l east 100 mm / 3.94 inches away from the device
and its mains adapter to ensure adequate ventilation.
• Never cover the ventilation slots of the device.
• Do not expose the device to extreme environmental conditions. Protect
the device from dust, humidity, and heat.
Connecting the mains adapter
Preparingforo perationMainsadapter
Observe the safety note s in the enclosed "Safety/Regulations" manual.
The supplied power cable conforms to the requirements of the country in
which you purchased your device. Make sure that the power cable is approved
for use in the country in which you in tend to use it.
3
1
2
► Connect the power cable (1) to the power
adapter provided for the device, see
chapter "
Technical data", Page 78.
► Plug the mains cable (2) into a mains outlet.
► Connect the USB Type-C cable (3) of
the power adapter to one of the two
Intel® Thunderbolt™ 4 USB p ower
ports of the device.
Fujitsu 23
To Next Page
Loading...
