Working w ith the notebook
Wireless components: wireless LAN / Bluetooth
/LTE/5G(optional)
The installation of radio components not approved by Fujitsu will invalidate
the certifications issued for this device.
Switching the wireless components on and off
► Press the function key
F5
to switch the wireless components on and off (flight mode).
WirelessLANWirelessLANBluetoothBluetoo th
If the F-Lock s etting of the keyboard is activated, you must press the key
combination
Fn
+
F5
key combination instead of the
F5
key.
If you disconnect the wireless components, the wireless LAN antennas and
the Bluetooth and LTE or 5G modules are disconnected.
Pay attention to the additional safety notes for devices with wireless components
provided in the "Safety/Regulations" manual.
You can obtain more information on LTE from your service provider.
Setting up WLAN acc ess
• Requirement: A W
LAN must be available and you must have the
corresponding
access information.
Information o
nconfiguring th e WLAN access can be found in the
documentatio
n for your operating system.
Ethernet and LAN
EthernetLAN
The internal network module of your notebook supports Ethernet LAN. You can use it to
establish a connection to a local network (LAN = Local Area Network).
Your network administrator can help you to configure and use the LAN connections.
The network cable is not included in the delivery s co pe. This type of
cable can be obtained from a specialist dealer.
Use a shielded network cable (CAT 5e).
Fujitsu 47
To Next Page
Loading...
