(1) Put the HDD into FCELL.
• At this time, the connector of the HDD is directed to the hinge side of FCELL.
• The PCBA is put in the side with the material mark of FCELL.
(2) Push from two corners of FCELL on the hinge side previously, push two corners of the opening
next, and lock FCELL surely.
(3) Put the above unitary packaging (packed in FCELL) into the conductivity bag by securing the
cushion.
(4) Put the HDD with conductivity bag into the cardboard box.
(5) Put the desiccant (10g) into the conductivity bag.
(6) Seal the conductivity bag with the packaging tape, then close the cardboard box.
C141-E270 109
To Next Page
Loading...
