Fujitsu MBA3073NC - Setting Terminals (on NP Model Only); Table A.1 CN2 Setting Terminal (on NP Model Drives Only)

A.1 Setting Terminals (on NP model only)
Table A.1 CN2 setting terminal (on NP model drives only)
Pin pair
Setting item
1 - 2 3 - 4 5 - 6 7 - 8 9 - 10
Setting contents
Open Open Open (Open) SCSI ID #0 (Common to 8-bit and 16-bit SCSI)
Short Open Open (Open) SCSI ID #1 (Common to 8-bit and 16-bit SCSI)
Open Short Open (Open) SCSI ID #2 (Common to 8-bit and 16-bit SCSI)
Short Short Open (Open) SCSI ID #3 (Common to 8-bit and 16-bit SCSI)
Open Open Short (Open) SCSI ID #4 (Common to 8-bit and 16-bit SCSI)
Short Open Short (Open) SCSI ID #5 (Common to 8-bit and 16-bit SCSI)
Open Short Short (Open) SCSI ID #6 (Common to 8-bit and 16-bit SCSI)
Short Short Short (Open) SCSI ID #7 (Common to 8-bit and 16-bit SCSI)
Open Open Open Short SCSI ID #8 (16-bit SCSI only)
Short Open Open Short SCSI ID #9 (16-bit SCSI only)
Open Short Open Short SCSI ID #10 (16-bit SCSI only)
Short Short Open Short SCSI ID #11 (16-bit SCSI only)
Open Open Short Short SCSI ID #12 (16-bit SCSI only)
Short Open Short Short SCSI ID #13 (16-bit SCSI only)
Open Short Short Short SCSI ID #14 (16-bit SCSI only)
SCSI ID
Short Short Short Short SCSI ID #15 (16-bit SCSI only) (*)
Open Write operation is enabled. (*) Write protect
Short Write operation is disabled.
Pin pair
Setting item
11 - 12 13 - 14 15 - 16 23 - 24
Setting contents
Motor start mode Open Started by the START/STOP command
Short Started by turning the power supply on (*)
Force Narrow Open Width of 16-bit bus (*)
Short Width of 8-bit bus
Force Single Ended Open Follows DIFFSNS signal level on SCSI bus (*)
Short Single-Ended mode
Terminating power supply Open Does not supply terminating resistor power to SCSI BUS
Short Supply terminating resistor power to SCSI BUS (*)
* Setting at factory shipment
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
118 C141-E270