Fujitsu MBA3073NC - Multi-Box Packaging; Figure 6.3 Multi-Box Packaging

6.5.2 Multi-box packaging
(upper)
(lower)
Figure 6.3 Multi-box packaging
(1) Put the conductivity bag into the milti-box, in addition put the cushion (lower) into the bag.
(2) Put unitary packaging (FCELL) in the cushion (lower).
• At this time, FCELL is put in the cushion (lower) so that the FCELL opening may become
downward. The I/F connector may become upward.
• For less than 20 HDDs, insert the HDDs starting from the slot with the smallest number in
Figure 6.4. Then place the empty FCELL in the empty slot.
(3) Hold the HDD with the cushion (upper)
(4) Put the desiccant (100g) into the conductivity bag
110 C141-E270