(5) External operator panel connector Signals
a. 16-bit SCSI –ID3, –ID2, –ID1, –ID0: Input signals (CN1-A1, A3, A5, A7 pin and CN2-02,
04, 06, 08 pin)
These signals are used for providing switches to set the SCSI ID of the HDD externally.
Figure 4.20 shows the electrical requirements. For the recommended circuit examples, see
Subsection 4.3.4.
Figure 4.20 16-bit SCSI ID external input
C141-E270 63
To Next Page
Loading...
