Interface
5-36 C141-E192-01EN
Bit 14-8: Undefined
Bit 7: Removable disk drive = 1
Bit 6: Fixed drive = 1
Bit 5-3: Undefined
Bit 2: IDENTIFY DEVICE Valid = 0
Bit 1-0: Reserved
*2 Word 1, 3, 6, 60-61
MHT2080AT MHT2060AT MHT2040AT MHT2030AT MHT2020AT
Word 01 X’3FFF’ X’3FFF’ X’3FFF’ X’3FFF’ X’3FFF’
Word 03 X’10’ X’10’ X’10’ X’10’ X’10’
Word 06 X’3F’ X’3F’ X’3F’ X’3F’ X’3F’
Word 60-61 X’950F8B0’ X’6FC7C80’ X’4A85300’ X’37E3E40’ X’2542980’
*3 Status of the Word 2 Identify information is shown as follows:
37C8h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
738Ch The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
8C73h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
C837h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
Others Reserved
*4 Word 49: Capabilities
Bit 15-14: Reserved
Bit 13: Standby timer value. ATA spec is '1.'
Bit 12: Reserved
Bit 11: 1 = Supported
Bit 10: 0 = Disable inhibition
Bit 7-0: Undefined
Bit 8: 1 = LBA Supported
Bit 9: 1 = DMA Supported
To Next Page
Loading...
