Fujitsu MHT2020AT - Error Posting

5.3 Host Commands
C141-E192-01EN 5-107
5.3.3 Error posting
Table 5.21 lists the defined errors that are valid for each command.
Table 5.21 Command code and parameters (1 of 2)
Command name Error register (X’1F1’) Status register (X’1F7’)
ICRC UNC INDF ABRT TK0NF DRDY DWF ERR
READ SECTOR(S) V V V V V V
WRITE SECTOR(S) V V V V V
READ MULTIPLE VVV VVV
WRITE MULTIPLE V V V V V
READ DMA V *2 V V V V V V
WRITE DMA V *2 VV VVV
WRITE VERIFY V V V V V V
READ VERIFY SECTOR(S) V V V V V V
RECALIBRATE V V V V V
SEEK VV VVV
INITIALIZE DEVICE PARAMETERS V V V V
IDENTIFY DEVICE V V V V
IDENTIFY DEVICE DMA V V V V
SET FEATURES V V V V
SET MULTIPLE MODE V V V V
SET MAX ADDRESS V V V V V
READ NATIVE MAX ADDRESS V V V V
EXECUTE DEVICE DIAGNOSTIC *1 *1 *1 *1 *1 V
READ LONG V V V V V
WRITE LONG V V V V V
READ BUFFER V V V V
WRITE BUFFER V V V V
IDLE V V V V
IDLE IMMEDIATE V V V V
STANDBY V V V V
STANDBY IMMEDIATE V V V V
V: Valid on this command
*1: See the command descriptions.
*2: Valid only for Ultra DMA command.