EasyManua.ls Logo

Fujitsu MS-6178MICROATX WH5 - Pnp;Pci Configuration Setup; Reset Configuration Data

Fujitsu MS-6178MICROATX WH5
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 3CHAPTER 3
CHAPTER 3CHAPTER 3
CHAPTER 3
AWARDAWARD
AWARDAWARD
AWARD
®
BIOS SETUP BIOS SETUP
BIOS SETUP BIOS SETUP
BIOS SETUP
3-24
3.9 PnP/PCI Configuration Setup3.9 PnP/PCI Configuration Setup
3.9 PnP/PCI Configuration Setup3.9 PnP/PCI Configuration Setup
3.9 PnP/PCI Configuration Setup
This section describes configuring the PCI bus system. PCI, or Personal
Computer Interconnect, is a system which allows I/O devices to operate at
speeds nearing the speed the CPU itself uses when communicating with its
own special components. This section covers some very technical items
and it is strongly recommended that only experienced users should make
any changes to the default settings.
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup if you
have installed a new add-on and the system reconfiguration has caused
such a serious conflict that the operating system can not boot.
The settings are: Enabled and Disabled .
Reset Configuration Data Disabled
Resources Controlled By Auto(ESCD)
IRQ Resources Press Enter
DMA Resources Press Enter
PCI/VGA Palette Snoop Disabled
Item Help
Menu Level >
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-safe defaults F7:Optimized Defaults
CMOS Setup Utility - Copyright(C) 1984-1999 Award Software
PnP/PCI Configuration Setup

Table of Contents

Related product manuals