Operation
Selecting input signal (D-SUB/DVI-D/HDMI)
► Press the
INPUT
/ buttontocalluptheInput select settings window.
► Press the
ECO
/ or the
INPUT
/ button to select the desired
monitor connection (VGA, DVI or DP).
► Press the
MENU
/ buttontoconfirm your selection or the
AUTO
/ button to cancel the process.
This setting window can also be c alled up when the OSD menu is locked.
Locking the OSD menu
The OSD menu can be locked to preven t accidental or unauthorised changes to the monitor settings.
► Press and hold the
MENU
/ button for a few seconds while you switch
on the monitor using the ON/OFF switch.
The m essage OSD locked / unlocked is displayed.
Please proce ed in the same mann er to release the locked OSD men u again.
Activate/deactivate ECO operating mode
The power consumption of the device can be decrease d by reducing
the brightness of the pictu re.
► Press the
ECO
/ button to switch the ECO operating m ode on or off.
The message ECO Mode ein or ECO Mode off appears.
If the ECO
operating mode is activated, the following OSD settings are changed:
Mode
Office
Colour
6,500 K
Brightness
reduced
After the ECO operating mode is switched off, the brightness previously set by the user is restored.
20 Fujitsu Technology Solutions
To Next Page
Loading...
