6.4 Cleaning the Server Blade
V CAUTION!
Switch off the server blade and remove it from the system unit (see
page 42).
Do not clean any interior parts of the server blade yourself; leave this job
to a service technician.
Do not use abrasive powder or detergents which dissolve plastic to clean
the housing exterior.
Make sure that no liquid gets inside the device and that the ventilation
slits on the ServerBlade remain open.
Wipe the server blade housing with a dry cloth to clean. If it is very dirty you can
use a damp cloth that has been dipped in water with a mild detergent and well
wrung out.
To Next Page
Loading...
