RX2530 M4
Operating Manual 47
5.2 Installing/removing the server in/from the
rack
V CAUTION!
●
Please observe the safety information and notes on rack mounting in
chapter "Important information" on page 33 and section "Notes on
installing the server in the rack" on page 41.
●
At least two people are needed to install / remove the server in the
rack. (For Japan, please refer to " 安全上のご注意 ".)
●
Do not extend more than one unit out of the rack simultaneously even
if the tilt protection is in place. If several units are simultaneously
extended out of the rack, there is a risk that the rack could tip over.
Fujitsu rack systems
The rack systems from Fujitsu support the installation of PRIMERGY servers:
– PRIMECENTER rack
– PRIMECENTER M1 rack
– DataCenter rack
– 19-inch standard rack (for Japan)
– 19-inch slim rack (for Japan)
I For information on mounting the server in the rack please refer to the
Mounting Instructions provided with the Rack Mounting Kit. Further
information you find in the manual of your rack system.
For Japan, please refer also to the "Rack system structure guide.
I Online documentation for rack installation can be found on:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
For Japan:
http://jp.fujitsu.com/platform/server/primergy/manual/peri_rack.html
To Next Page
Loading...
