TX100 S3 Operating Manual 37
Important information
To bring your system into S4 mode (= hibernate mode), proceed as follows:
BIOS Setup
Ê In the Power menu of the BIOS setup, set the 0-Watt PC Feature parameter to
Disabled, if the installed power supply is a 0-Watt power supply.
Operating system Microsoft Windows 2008 Enterprise Edition
Activation
Ê Open a DOS shell using C:\Windows\System32\cmd.exe and enter the
following command to activate S4 mode:
powercfg -h ON
Configuration
To set the driver for the internal LAN controller:
Ê Open the Device Manager via Start - Control Panel - System - Device Manager.
Ê Select Network Adapters.
Ê Select one of the internal LAN controller: Intel
®
82574L or 82579LM Gigabit
Network Connection.
Ê Select Properties in the overview, and then select Power Management.
Ê In the Wake on LAN field, enable the following option:
– Wake on Magic packet
Ê Press OK.
Execution
To execute the power down command in a DOS shell:
Using the shutdown -h command, your system saves all user data (e.g: open
windows and running programs), shuts down the system, and transfers it to S4
mode.
Exiting the hibernate/idle state (S4 mode)
You switch on the system again either manually using the On/Off button or using
the WOL function (WOL= Wake-up On LAN).
To Next Page
Loading...
Need help?
General