Fujitsu Printer - User Manual

1
THERMAL PRINTER - OPERATING MANUAL
PC Device Port Set (Windows)
Procedure:
My Computer
Control Panel Open
System
Device Manager
Ports (COM & LPT)
Communications Port (COM1)
Port Settings
Bits per second 19200, 9600, 4800, 1200
Data bits 8, 7
Parity Even, odd, none
Stop bits 1
Flow control Xon, Xoff, Hardware (DTR/DSR)
PC Device Port Set (MS-DOS)
Procedure:
Case 1: Windows Prompt
Start
Programs
MS-DOS Prompt
C: \Windows> mode com1:19200, e, 8, 1
C: \Windows> copy <file name>com1
C: \WIndows >exit_______________< = to restart Windows
Case 2: MS-DOS
Start
Shut down
Restart the computer in MS-DOS mode?
Yes
C: \Windows> mode com1:19200, e, 8, 1
C: \Windows> copy <file name>com1
C: \WIndows >exit_______________< = to restart Windows
Note: If the data is large, send the data in Windows prompt mode, otherwise system will be
interrupted. In this case, use the actual MS-DOS mode (case 2).

Fujitsu Printer Specifications

General

Brand	Fujitsu
Model	Printer
Category	Printer
Language	English

Summary

PC Device Port Configuration

Windows Device Port Settings

Procedure to access Device Manager, select COM1, and configure port settings like baud rate, data bits, parity, stop bits, and flow control.

MS-DOS Port Configuration via Windows Prompt

Steps to configure the COM1 port using the 'mode' command and copy files within a Windows command prompt environment.

MS-DOS Port Configuration in MS-DOS Mode

Procedure to set COM1 port parameters using the 'mode' command and copy files when the system is booted into MS-DOS mode.

Connection Testing

Preparing Print Sample

Steps to create a test print file named 'testprt.prn' using the MS-DOS editor with sample text.

Communication Test

Procedure to test communication via parallel (LPT1) and serial (COM1) ports using the created print sample file.

MS-DOS Editor and Batch File Operations

MS-DOS Mode Editor Usage

Instructions for using the MS-DOS editor to create and save files, including navigation with keyboard shortcuts.

Editing Serial Interface Batch File

Procedure to create and edit a batch file ('stest.bat') for serial interface communication via the MS-DOS editor.

Batch File Usage

Editing Parallel Interface Batch File

Procedure to create and edit a batch file ('ptest.bat') for parallel interface communication using the MS-DOS editor.

Sample Program Load and Execution

Steps to load, check, and run sample batch programs for serial and parallel interface communication.