Fujitsu Remote Control Operating Manual

En-9
SWING OPERATION
Left/right and up/down/left/right swing operation cannot be performed on models that are not equipped with horizontal air-
flow louvers.
Begin air conditioner operation before performing this procedure.
Up/down swing operation Left/right swing operation
Swing operation stops Up/down/left/right swing operation
About Swing Operation
● Left/right swing: The airflow-direction louvers move (swing) in the left/right airflow direction.
● Up/down/left/right swing: The airflow-direction louvers move (swing) in both the up/down and left/right airflow directions.
● The SWING operation may stop temporarily when the air conditioner’s fan is not operating, or when operating at very low
speeds.
● If the SET button (Vertical) is pressed during the up/down swing operation, the up/down swing operation will stop and if the
SET button (Horizontal) is pressed during the left/right swing operation, the left/right swing operation will stop.
● The swing operation is not available depending on the model. Please refer to the MANUAL (OPERATING) which is included
in INDOOR UNIT.
To select SWING Operation
Press the SWING button.
Each time the SWING button is pressed, the swing operation will change in the
following order.
To stop SWING Operation
Press the SWING button and select STOP.
Airflow direction will return to the setting before swing was begun.
ECONOMY OPERATION
Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button.
“ECO” appears on the Remote Control Unit display.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button again.
“ECO” disappears from the Remote Control Unit display.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation for cooling and
heating.
When ECONOMY operation is performed during the cooling mode, dehumidification is improved. This function is especially
convenient when you want to remove the humidity in the room without significantly lowering the room temperature.
During ECONOMY operation, the thermostat setting automatically changes according to the temperature to avoid Unneces-
sary cooling and heating for the most economical operation.
● If the room is not cooled (or heated) well during economy operation, select normal operation.
● Once air conditioner operation is stopped, normal operation begins when the indoor unit is turned on again.
● During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.

Fujitsu Remote Control Specifications

General

Brand	Fujitsu
Model	Remote Control
Category	Remote Control
Language	English