En-10
When two or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other
than the one you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to
set (four selections possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner
signal codes.
SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
) until you find the
code which operates the air conditioner.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote control unit. (Note
that the air conditioner cannot receive a signal code if the air conditioner has not
been set for the signal code.)
1
Press the START/STOP button until only the clock is
displayed on the remote control unit display.
2
Press the MODE button for at least five seconds to dis-
play the current signal code (initially set to
).
3
Press the buttons to change the signal code be-
tween
. Match the code on the display to the
air conditioner signal code.
4
Press the MODE button again to return to the clock
display. The signal code will be changed.
To Next Page
Loading...
Need help?
General
