Fujitsu Remote Control - Table of Contents; Safety Precautions

En-1
SAFETY PRECAUTIONS
● Before using the appliance, read these “SAFETY PRECAUTIONS” thoroughly and operate in the correct way.
● The instructions in this section all relate to safety; be sure to maintain safe operating conditions.
SAFETY PRECAUTIONS................................................ 1
NAME OF PARTS ........................................................... 2
PREPARATION ............................................................... 3
OPERATION ................................................................... 4
TIMER OPERATION ....................................................... 6
SLEEP TIMER OPERATION ........................................... 7
FILTER LAMP RESET ..................................................... 7
WAERNING!
This mark indicates procedures which, if improperly performed, might lead to the death or serious
injury of the user.
CAUTION!
This mark indicates procedures which, if improperly performed, might possibly result in personal harm
to the user, or damage to property.
• Do not expose the controller directly to water.
• Do not operate the controller with wet hands.
• Do not touch the switches with sharp objects.
• Always turn off the electrical breaker whenever clean-
ing the controller, the air conditioner or the air filter.
• Ensure that any electronic equipment is at least one
metre away from the controller.
• Avoid installing the controller near a fireplace or other
heating apparatus.
• Do not use inflammable gases near the controller.
CONTENTS
ADJUSTING THE DIRECTION OF
AIR CIRCULATION ......................................................... 8
SWING OPERATION ...................................................... 9
ECONOMY OPERATION ................................................ 9
SELECTING THE REMOTE CONTROL UNIT
SIGNAL CODE.............................................................. 10
TROUBLESHOOTING .................................................. 11
• If a problem (burning smell, etc.) occurs, turn off the electrical breaker immediately to stop operation, and then consult
authorized service personnel.