Fujitsu ScanPartner SP30

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
137
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Operational
Settings
Number of Paper Feeding Retries
Configure this setting to change the number of feeding retries
when a pick error occurs.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 116).
2 From the listing on the left, select [Device Setting 2] J
[Number of paper feeding retries].
3 Specify the number of paper feeding retries.
The value can range from 1 to 12 times.
Scanning at High Altitude [High Altitude Mode]
Select whether to enable or disable high altitude mode.
Low atmospheric pressure at high altitudes may cause the
accuracy of the multifeed detection for the ultrasonic sensor to
be reduced.
Enabling high altitude mode allows you to use the scanner at
an altitude of 2,000 m or higher.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 116).
2 From the listing on the left, select [Device Setting 2] J
[High Altitude Mode].
3 Select whether to enable or disable [High Altitude Mode].