Notice
Make sure that both ends of the Guide-P-ASSY (sheet guide) are locked firmly.
(4) Close the ADF top section.
Resetting the Number of Consumable Usage
After replacing the consumables, reset the number of consumable usage in the following procedure.
(1) Tap in the home screen on the touch panel of the ScanSnap to display the [Settings] screen.
(2) Tap to display the [Maintenance] screen.
(3) Tap [Check consumable status] to display the [Check consumable status] window.
(4) Tap [Reset].
(5) When the message appears, tap [OK].
The value for [Current Count / Replacement Cycle] becomes [0].
Be careful not to get your fingers caught when closing the ADF.
To Previous Page
Loading...
