Installation
(1) Insert the left end of the shaft into the slot (①), and lower the other end gradually (②).
(2) Rotate the bushing on the Pick-Roller-ASSY in the direction of the arrow (see the lower right figure).
(3) Close the Guide-P-ASSY (sheet guide).
ATTENTION
Confirm that the pick rollers are attached properly. Otherwise, paper jams or other feeding errors may occur.
Make sure you insert the pick rollers until they lock in place.
ATTENTION
Confirm that the pick rollers are installed properly. Otherwise, paper jams or other feeding errors may occur.
To Next Page
Loading...
