Before replacing the consumables, check the status of each consumable in the following procedure.
(1) Tap in the home screen on the touch panel of the ScanSnap to display the [Settings] screen.
(2) Tap to display the [Maintenance] screen.
(3) Tap [Check consumable status] to display the [Check consumable status] window.
(4) Check the value for [Current Count / Replacement Cycle].
Note that the suggested replacement cycles are guidelines for using A4 (80 g/m
2
[20 lb.]) wood-free or wood-containing
paper, as these cycles vary depending on the type of documents scanned and how often the scanner is used and
cleaned.
For information on purchasing the consumables, contact the distributor/dealer where you purchased this product. Or,
make an inquiry by referring to the contact information at the Contact for Inquiries section in Safety Precautions
bundled with this product.
Replacing the Brake Roller
Replace the brake roller in following procedure.
(1) Open the ADF top section.
(2) By holding the both ends of the Guide-R-ASSY (brake roller cover), open it in the direction of the arrow.
HINT
Only use the specified consumables.
To Next Page
Loading...
