Controls Control panel (on the SE700 and SE500)
U41858-J-Z126-2-76 45
Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
Dokuschablonen 19x24 Version 7.4us für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
12. April 2017 Stand 18:58.59 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303913_BA_Basis_update_2\prod_e\ba_basis.k05
The control panel contains the following controls and displays (please refer to the numbers
in the figure):
1. UNIT EMERGENCY switch
The UNIT EMERGENCY switch switches the SU /390 off.
2. POWER ON button with lamp
Switches the Server Unit on. When the SU /390 is switched on, POWER ON lights up
green.
3. STAND-BY button
Switches the SU /390 off, but not currentless (power supply units in standby mode).
4. SYSTEM lamp
Displays whether the CPUs of the SU /390 are active.
5. CHECK lamp
Shows whether a fault has occurred.
6. STATUS indicator
Supplies detailed information on the hardware status.
The function of the displays and controls in the operating panel is described in the sections
below.
To Next Page
Loading...
