En-10
When you return to the “Monitor” screen, the icon is displayed.
To check the function, press the [Enter button] and select the
icon.
Cool
Monitor
High
°
C
24
Menu
Set temp. auto return: Remaining 30 minutes
Mo
10:00
End:
3-2-4. Set temp. range limitation setting
1
In “Function” screen, select [Set temp. range] with the
[Cursor button (Up/Down)].
Function
Air flow direction
Economy
Set temp. auto return
Set temp. range
Off
Disable
Timer
Mo
10:00
Disable
Setting:
Back:
To change the setting, press the [Enter button].
2
“Set temp. range” screen is displayed.
Set temp. range
Enable/Disable setting
Temp. setting
Cool/Dry
Heat
Auto
Lower
Upper
18
°
C
30
°
C
30
°
C
30
°
C
16
°
C
18
°
C
Disable
Mo
10:00
Setting:
Back:
Set temp. au...
Air flow dire...
Select the item with the [Cursor button (Up/Down)], and
press the [Enter button].
3
For [Enable/Disable setting], select [Enable] or [Disable]
with the [Cursor button (Up/Down)], and press the [Enter
button] to complete the setting.
Enable/Disable setting
Enable
Set temp. range
Temp. setting
Cool/Dry
Heat
Auto
Lower
Upper
18
°
C
30
°
C
30
°
C
30
°
C
16
°
C
18
°
C
Mo
10:00
OK:
Cancel:
Set temp. au...
Air flow dire...
4
For [Temp. setting], select mode with the [Cursor but-
ton (Up/Down)] and press the [Enter button].
Adjust [Lower] and [Upper] value with the [Cursor but-
ton (Up/Down)].
With the [Cursor button (Left/Right)], the cursor can be
switched [Lower] and [Upper].
To complete the setting, press the [Enter button].
Set temp. range
Enable/Disable setting
Temp. setting
Cool/Dry
Heat
Auto
Lower
Upper
18
°
C
30
°
C
30
°
C
30
°
C
16
°
C
18
°
C
Enable
Mo
10:00
Set temp. au...
Air flow dire...
OK:
Cancel:
Notes
• Possible temperature setting ranges in the operation
mode are as follows:
Cool, Dry, Auto ................ 18 to 30 °C (64 to 88 °F)
Heat ................................. 16 to 30 °C (60 to 88 °F)
• If the temperature out of the Set temp. range limitation
is set, it will be reset at the nearest temperature within
the range.
• Even if the temperature setting change is done on the
secondary remote controller, it returns to temperature
within the range set in [Set temp. range] on the
primary remote controller.
When you return to the “Monitor” screen, the icon is displayed.
To check the function, press the [Enter button] and select the
icon.
Menu
Cool
Monitor
Mo
10:00
High
°
C
26
Set temp. range
End
:
9380221043_OM.indb 10 8/22/2012 3:54:58 PM
To Next Page
Loading...
Need help?
General
